RAV4 L4-2.0 (3S-FE) 1998 no spark
Hello! I need help. The problem: a RAV4 L4-2.0 (3S-FE) has no check engine light and of course won't start. I searched the forum and found nothing. Earlier there was no spark at all. Yesterday I found the cause: a problem with the crankshaft position sensor (CKP). The insulation on the wiring had burned off. I restored everything and it was fine. We drove for 2 hours, got home, and then it died again: no spark and no fuel. Diagnostics through the scanner shows nothing. I checked the circuit from the CKP to the ECU and it is fine. The check engine light still doesn't come on, and of course the engine won't start, with no spark and no fuel. What could the cause be? I checked the ECU power supply against the wiring diagram: pin 5 has no positive. That line comes from the ignition signal and the instrument cluster, I think. We replaced the CKP sensor.
Are the EFI fuses intact? I had something similar on a Mark II. The front right fender had a damaged wiring harness that had been repaired with twisted joints, and there was no inner fender liner. The twisted joints oxidized. The positive from the main relay under the hood to the ECU, under the glove box, would drop out.
Yes, and I checked all the relays too, and they all work. I can't find the IG1 relay or the fuse after the IG1 relay on the power contact.
Which ignition system is it, with a distributor or coils? What was done before this? Check the grounds. I had something similar on a Crown: an 80A fuse had oxidized, I think. I would pull the fuses and check them with an ohmmeter.
Thanks everyone, the car is running! The problem was the ECU: it had no input and no output!