Autopapyrus · Ford Focus III
https://autopapyrus.com/catalog/ford/focus/guides/front-brake-pad-replacement/
https://autopapyrus.com/catalog/ford/focus/guides/front-brake-pad-replacement/
Compiled automatically from service literature and owner experience. Specs are for the typical configuration — check them against your exact car before you start.
Ford Focus III: Front Brake Pad Replacement
The front brake pads on the Ford Focus III should be replaced every 20,000-30,000 km (12,000-18,000 miles), depending on driving style. The procedure does not require removing the caliper from its guide pins. It is enough to swing it out of the way.
Part
| № | Part | Alternatives |
|---|---|---|
| 01 | Front brake pads Ford (Ferodo) or Ford (Motorcraft)setFind on Amazon → | AlternativesBoschFerodoTextar |
Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.
Tools
6
There's a full repair manual for this car
Every system, wiring diagrams and torque specs — not just this job. Haynes and 25 more.
See manuals →
Step by step
13 steps- Raise the front of the vehicle with a jack and remove the wheel.
- Loosen the brake fluid reservoir cap in the engine bay so that fluid does not get forced out when you push the piston back.
- Carefully press the caliper piston inward with a flat-blade screwdriver inserted between the rotor and the pad (do not damage the rotor).
- Remove the lower caliper guide bolt with a 13 mm socket.
- Swing the caliper upward around the upper bolt. Do not let the caliper hang by the brake hose. Support it or tie it to the suspension with wire.
- Remove the old pads from the caliper bracket and take out the retaining springs (if fitted).
- Clean the pad seats on the bracket of dirt and rust, and apply a thin layer of dedicated caliper grease to the guide pins (not to the friction surfaces of the pads).
- Install the new pads with the retaining springs.
- Lower the caliper back into place and tighten the guide bolt to 28 N·m (21 lb-ft).
- Install the wheel, tighten the wheel bolts, and lower the vehicle.
- Press the brake pedal firmly several times until the piston brings the pads up against the rotor.
- Check the brake fluid level and top up to the MAX mark if necessary.
- Bed in the new pads over the first 200-300 km (125-185 miles) and avoid hard braking.
Common mistakes and warnings
- For the first several stops after replacing the pads, braking performance will be reduced
- This is normal, as the pads are bedding in to the rotors
- Do not overload the brakes during the first few kilometers
- Check the condition of the brake rotors: if the thickness is less than 20-21 mm or there are deep grooves, replace them along with the pads
- New rotors are 25 mm thick, and the minimum allowed by Ford specification is 23 mm
How it works · 3D
How Car Brakes Work
How the part you're working on actually works — in plain English, on a 3D model.
Open in 3D →
Spotted a mistake? Tell us →
Our articles
Brand stories
The History of Ford
Ford Motor Company is the largest American automaker by heritage and one of the most recognizable car brands in the…
Read →
Garage
Fuel Quality Indicators: What Octane and Cetane Numbers Mean
What is an octane number? What about a cetane number? Which fuel should you choose for a high-compression engine?…
Read →
Before you buy
How to Pick Up Your Car from the Dealership the Right Way
If you've decided to buy a car from a dealership, it isn't enough to simply choose a model you like, pay for it, and…
Read →