← Carisma

Mitsubishi Carisma 1.8 GDI 4G93 (2004): Ignition Coil Replacement

On the 1.8 GDI (4G93), each coil sits directly on the spark plug, and there are no high-voltage spark plug wires. You can replace a single faulty coil or all four at once. Symptoms of a failing coil: misfires, rough running on three cylinders, a flashing Check Engine light, and misfire trouble codes. The job is simple, but do it on a cold engine.

DifficultyEasy Time30-40 minutes Steps14

Part

№PartGenuine part no.Alternatives
01 Ignition coil, 4G93 GDI (one per cylinder)4 pcsFind on Amazon → MD362913 AlternativesNGKDensoBosch
MD366821

Amazon links search by the part name and genuine number; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Part numbers are from the manufacturer's original catalogue. Check them against your VIN before ordering.

Tools

5

Step by step

14 steps
  1. Turn off the engine, let it cool down, and disconnect the negative battery terminal. The firing order is 1-3-4-2, and cylinders are numbered starting from the timing belt side (the pulley side).
  2. Remove the decorative plastic engine cover. On GDI engines, all access to the spark plugs and coils starts with this cover.
  3. Identify the faulty coil. With the engine off, swap two adjacent coils and check whether the misfire code follows the coil to the other cylinder.
  4. Clean the area around the coils with compressed air or a rag so dirt does not fall into the spark plug well.
  5. Press the lock and disconnect the coil's electrical connector. Pull on the connector body, not on the wires.
  6. Remove the coil mounting bolt with a 10 mm wrench. If a ground wire is secured under the same bolt nearby, set it aside, and make sure you don't lose it or mix up its location.
  7. Pull the coil straight up, rocking it gently along its axis. The rubber boot may be stuck to the spark plug, so pull straight without tilting it.
  8. Inspect the well: if there is oil or water in it, find the cause (valve cover gasket, spark plug well seals) before installing the new coil. Check the rubber boot for cracks and signs of electrical arcing.
  9. While you're there, check the spark plugs. If they are worn out, replace them (16 mm socket). Use the manufacturer's specifications for spark plug torque and gap.
  10. Push the new coil onto the spark plug until it is fully seated and align the bolt hole.
  11. Tighten the coil mounting bolt carefully: approximately 8-12 N·m (6-9 lb-ft). Confirm the exact value in the manufacturer's specifications. Do not use force, because the plastic housing cracks easily. Reinstall the ground wire if you removed it.
  12. Connect the connector until the lock clicks.
  13. Install the decorative cover and reconnect the battery terminal.
  14. Start the engine: the idle should be smooth and the Check Engine light should be off. If errors remain, read them with an OBD scanner and clear them after the cause has been fixed.

Common mistakes and warnings

  • The GDI direct-injection engine operates at high fuel pressure
  • Do not disconnect fuel lines or touch the injectors during this job
  • Do not disconnect coil connectors while the engine is running: the secondary circuit voltage is high
  • If misfires continue after replacement, the cause is most likely the spark plugs, an injector, or compression, so take the car to a repair shop for diagnosis
Spotted a mistake? Tell us →

Test yourself