Autopapyrus · Toyota Hilux Surf N180 (3rd Generation)
https://autopapyrus.com/catalog/toyota/hilux-surf/guides/checking-the-automatic-transmission-fluid-level/
https://autopapyrus.com/catalog/toyota/hilux-surf/guides/checking-the-automatic-transmission-fluid-level/
Compiled automatically from service literature and owner experience. Specs are for the typical configuration — check them against your exact car before you start.
Toyota Hilux Surf N180 (3rd Generation): Checking the Automatic Transmission Fluid Level
Checking the fluid level in the automatic transmission of a Toyota Hilux Surf N180 with the 3RZ-FE engine is done with the transmission warmed up and the engine running. The procedure takes about 15 minutes and requires no special equipment.
Part
| № | Part |
|---|---|
| 01 | ATF Dexron III automatic transmission fluidfor topping off, usually 0.2-0.5 L (0.2-0.5 qt); total transmission capacity about 7.6 L (8.0 qt); if neededFind on Amazon → |
Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.
Step by step
10 steps- Warm up the transmission. Drive 10-15 km under normal conditions, or let the engine idle for 5-10 minutes while shifting the selector lever through all positions (P-R-N-D-2-L and back). The ATF temperature should be 70-80 °C.
- Park the vehicle on a level, flat surface and set the parking brake.
- Move the selector lever to P (Park). The engine must keep running at idle.
- Open the hood and find the transmission dipstick. It is usually located at the rear of the engine compartment, close to the firewall, and has a red or yellow handle marked ATF or Transmission.
- Pull the dipstick all the way out and wipe it with a clean rag or paper towel.
- Push the dipstick all the way back in, then pull it out again and read the fluid level.
- On a warmed-up transmission, the normal level is between the HOT (upper) and COLD (lower) marks, closer to HOT. The difference between these marks is approximately 1 L (1.1 qt).
- Check the condition of the fluid. It should be clear with a pinkish tint. Dark color or a burnt smell indicates the ATF needs to be replaced.
- If the level is below the HOT mark, add fluid through the dipstick tube using a funnel in small amounts (0.2-0.3 L (0.2-0.3 qt) at a time), checking the level after each addition.
- After checking, push the dipstick back in all the way and close the hood.
Common mistakes and warnings
- Checking the ATF level on a cold transmission gives incorrect readings, because the fluid expands as it heats up
- Always check with the transmission warmed up and the engine running
- Overfilling is just as harmful as underfilling
- It can cause the ATF to foam and damage the valve body
- Do not shut off the engine during the check, because the fluid will drain back into the pan and the reading will be too low
How it works · 3D
How an Automatic Transmission Works
How the part you're working on actually works — in plain English, on a 3D model.
Open in 3D →
Spotted a mistake? Tell us →
Our articles
Brand stories
The History of Toyota
From weaving looms to reliable mass-produced cars.
Read →
Garage
Fuel Quality Indicators: What Octane and Cetane Numbers Mean
What is an octane number? What about a cetane number? Which fuel should you choose for a high-compression engine?…
Read →
Before you buy
How to Pick Up Your Car from the Dealership the Right Way
If you've decided to buy a car from a dealership, it isn't enough to simply choose a model you like, pay for it, and…
Read →