Kia Shuma diagnosed as 'won't start'
Need advice. A 1999 KIA Shuma was towed in today with a diagnosis of 'won't start'. On checking, there is no spark and the injectors don't fire. 1. When the ignition is switched on, the fuel pump relay clicks, and the CHECK and IMMO lights come on. 2. The fuel pump relay switches off and the IMMO light goes out. 3. When cranking starts, a spark flashes on 1-4 (0.1-0.5 sec.), while 2-3 stay silent. Replacing the coils changes nothing. 4. While cranking with the starter, the fuel pump relay switches on and one pair of injectors, 1-4 or 2-3, opens (I don't remember exactly which). I don't know whether to blame the immobilizer or the ECU. PS. I don't have a KIA diagnostic scanner, but before me the car had been in various other places, and they said the ECU sees the crankshaft position sensor and that the ECU is faulty. PPS. The car failed suddenly: the driver switched it off, and 10 minutes later it wouldn't start.
Is the engine 1.5, 1.6 or 1.8? For the 1.5 and 1.8 there is a wiring diagram in Bosch ESI.
The engine is a 1.5 BF. I don't have Bosch ESI.
What do you mean you don't have it? Wasn't it sent out to everyone? Remind me tomorrow and I'll send it over, unless the guys from the Association get there first.
I have the software discs, but far from all of them can be read. I just decided not to make a fuss and get by with the minimum for now.
A diagram is a diagram. But what should I blame, the ECU or the immobilizer? If it's the ECU, it is potted in compound and the components can't be seen. If it needs replacing, how do I register the immobilizer in the new unit?
I'm sure the immobilizer has lost its programming, all the signs point to it. It's a national disease for them. It usually happens after a voltage drop at the moment of starting, caused by a weak battery. I've had a Sephia sitting behind my fence for a year with the same problem. The customer is looking for a unit from an Avella, which has no immobilizer, because getting the car to the official dealers isn't realistic. Search online. There are two or three methods and algorithms for getting around this problem.
As I understand it, the immobilizer has lost its programming. Can anyone tell me how to restore it or retrain it?
Either with a scanner, or erase the EEPROMs. Go to the immobilizer section on the Oktyabrsky forum, the guys there are knowledgeable. Do you have another key? Try the second key.
Exactly the same fault. How did it end?
If you have a Carman Scan, use that. If you need a login, message me privately.
The car was taken away. It looks like it ended with the keys being reprogrammed.