Kia Sorento 3.3 Petrol 2008 High Fuel Consumption
Hello, colleagues! This car came in for repair with a complaint of high fuel consumption. It was bought recently, so there are no statistics. According to the customer, repeated measurements gave 26 to 30 l/100 km. There are no fault codes in memory, but when checking parameters, the signal from the first O2 sensors is around 1.1 V. Long-term trims on both banks are OK at -15%, short-term trims -5-6%, MAF 13.2 kg. Judging by the deposits on the spark plugs, there shouldn't be such consumption: the insulator is white. I have had almost no such engines in for repair. Why is there such a signal from O2 sensor 1? Or could it be a short in the heater circuit? But that is unlikely on both sensors. Any thoughts on this?
How did he measure it? By the trip computer? Also, there is certainly a remote-start alarm fitted! It can show 50 instead of 100.
The measurement was done on my recommendation: fill up to the brim, reset the odometer, drive 200-250 km, fill up to the brim again and calculate. The engine runs smoothly, with no complaints about its operation.
Is a remote start fitted? The engine idles roughly when cold, and it only drives 5-10 km at most. It is -30 outside.
Which market is the car for?
I agree about short trips: a poorly warmed-up engine uses more. About the remote start, I don't know, but I think there isn't one. I will find out. Outside today it is -10, and before that -3 to -6. Not really frost, in short. I also suspected a transmission problem: when Low is selected, the low range engages and the clutch in the transfer case locks, which the pictogram with the axles and driveshaft indicates. It does not light up, and on a hard start you can see the clutch is not locked: first the rear wheels spin, then the front picks up. (This is about whether the clutch locks while driving, causing power flow circulation.) The car is for Europe, definitely not a US car. It was bought here, mileage about 40000 km, it doesn't look like it was driven hard. I am more interested in O2 sensor 1: high voltage and corrections of -15%.
Today it came in for a deeper check. I connected again: the trim is negative (-15) on the second bank. O2 sensor 1 also shows rich (about 0.9-1.0 V). I measured compression: 9.0, 11, 12, 10.5, 10.5, 10.5. On the first three cylinders the spark plug threads are in oil (hence the raised compression). The alarm has no remote start. It is unlikely that this could affect consumption that much. The injectors are not leaking: the intake ports are dry.
Look at the O2 sensor's response to enrichment and leaning with an oscilloscope (or at worst a scan tool); it may simply be dead.
There is a response only when revving, not at idle. And only on the second bank. I simply disconnected it and the engine started running more smoothly (before, there was a barely noticeable vibration through the steering wheel, as with a lean mixture). In limp mode it injects more fuel, hence the evening out. We'll see about consumption while it is driven, until the O2 sensor is delivered. By the way, the check engine light never came on, although there is a fault for an open heater circuit (the bulb works).
There was a case with a V6 where the O2 sensor wiring was swapped between the left and right sides. It seemed impossible, though. I think it was a Lexus. Maybe check the correspondence here too.
Clearly over-rich. If all parameters are normal (MAF, coolant temperature sensor, voltage, etc.), try disconnecting the charcoal canister, smell the oil, and measure the fuel pressure. Disconnect the O2 sensor and look at the voltage; it may be the wiring. Check the injectors. And the worst case: the injectors don't match and the tune is crooked, supposedly to increase power (the fault comes on at a long fuel trim of 12.5%). Almost forgot: these are typical parameters for a clogged catalytic converter.