Volkswagen Scirocco, 1.4 L, 2011, CAVD, Misfires on cylinders 2 and 4 after engine rebuild
Volkswagen Scirocco, VIN wvwzzz13zbv029972. The engine was repaired because the piston ring lands (the partitions in the pistons) were broken. The turbo cartridge was also replaced, because the engine was pushing a lot of oil into the intake. On disassembly, mismatched pistons were found, so it was decided to bore the cylinders to +0.50 and use Janmar pistons. It was bored, assembled and started, and it ran like clockwork with no problems. But after the revs were raised to 2000, the check engine light started flashing. The fault is misfires on cylinders 2 and 4. There are no misfires that can be heard, and while driving the fault is only logged when the car is coasting at 1500-2500 rpm. Above 3000 rpm and at idle, the fault is not logged. What has been done: ignition coils from a donor car were fitted, the injectors were swapped to other cylinders, and the engine was taken apart again, with the valves lapped and the piston-to-wall clearance measured at 0.3-0.4 (hundredths of a mm). There is no cylinder taper. Compression is even at 14 kg by my gauge, but the faults come back just as before. If you keep driving with the fault, the cylinders get shut off. My own head is already misfiring, so what can anyone advise in this situation?
Within 30 seconds of the misfires appearing, clear the faults. Do it three times. Report back.
This topic has already been raised here on the forum. It is apparently fixed by writing the factory firmware through OBD. Writing the original firmware through OBD forcibly resets all adaptations, and then all will be well.
Do you clear the faults three times, or does the fault appear three times and you clear it three times? Anyway, I cleared the faults three times in a row. And the faults did not come back! I started it and revved it, and everything was fine? I'm utterly amazed!
What is the order? Clear the fault the first time, then wait for it to appear and clear it again?
Just press the "clear faults" button three times. Right?
Yes, press the clear button three times. My question is about disconnecting the battery: why did the faults come back after the power was cut?
ODIS now has a function called "reset long-term adaptation of misfires". As a temporary solution, there was the method of clearing the faults. If that did not help, then reflashing with custom software. But only on one condition: that there are no real misfires.
If the events keep coming back, then the problem is in the hardware after all. There was one car after the crankshaft position sensor was replaced at an outside shop. It did all kinds of things because it was installed crookedly. Are you sure there are no other events?
I haven't come across anything like this in the MED17 before...