← Opel

Opel Astra - problems with the robotized gearbox

Opel Astra 7 answers Translated from Russian · original

There is no clutch. If I don't press the gas a little when pulling away, it stalls. Fault P1707 is stored: clutch coefficient/touch point limit reached during programming. Op-Com also shows this error. What can be done to reset the coefficient limit?

Answers
O
Owner Jan 23, 2020

Read the manual. Op-Com gives no hints on adapting the clutch touch point. Or adapt it with Autocom, if the disc itself and the brushes in the actuators are OK.

O
Owner Jan 31, 2020

What is the mileage? The clutch most likely needs replacing. If you run an adaptation with Op-Com, the car may not move at all afterward and may go into limp mode.

O
Owner Feb 04, 2020

Yes, the clutch is worn out. Even with Tech2 or MDI you can't change anything now. The permitted value seems to be 14 mm.

O
Owner Feb 13, 2020

I sent it to the mechanics to replace the clutch and the brushes. Thanks, everyone.

O
Owner Jul 03, 2020

Check the wiring to the brush unit of the motor, as already said above. The clutch may also need replacing. At the extreme end of wear, the motor stops starting altogether.

O
Owner Sep 16, 2020

If you run an adaptation with Op-Com, the car may not move at all afterward and may go into limp mode. This happened a couple of times. Before the trip to the service center, the car still drove somehow. An error appeared during the adaptations, and the car couldn't leave the service center.

O
Owner Oct 08, 2020

I adapted the clutch today and it showed 9.3 mm. Is that normal?

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →