Lighting problems: left side parking lights and left low beam, Ford Ranger
The left side parking lights don't work when I switch them on. If I turn the ignition on, they work, but only the front ones. The left low beam doesn't work. Where should I start? I've checked the switch and all the fuses. I assume there's a light control module. Where is it located, and in which fuse box: under the hood or in the cabin?
I tested the wires from the low beam bulb to the fuse box in the cabin, the one on the left under the steering wheel. I took it apart. It has two boards soldered together. The top board has relays the size of a big beetle. What can a relay like that handle, a 10-watt bulb? Crazy! I can't test the pins because the tracks come in from the inside. The boards would have to be desoldered. Four rows of contacts hold the top board! I don't have a soldering iron big enough, so I'm waiting for one to be brought in from the region!
Can't you check the BCM with a scanner and see what's going on? Clear the errors...
Is it all fine after you replaced the burnt-out bulbs?
The nearest service station with a scanner is 300 km away. We don't have one YET. We're expecting one in the next few days. I haven't dealt with the parking lights yet. But the low beam flickered for a long time before it went out. If you knock on it, it lights up.
In short, on these cars, for example the Focus 3 and Transit, when a bulb burns out or there's a short circuit, an error is stored in the BCM, and there will be no voltage until you clear it.
I ran the low beam through an extra relay. I'll wait for the scanner to arrive, or for the car's owner to get to civilization, to deal with the parking lights. If the low beam recovers as well, I'll remove the relay.
Desoldering sandwiches like that costs more than it's worth. It's easier to cut the pins and then solder them back together. And the repair here should start with a scanner.
But you can't see which pins and which tracks go to the relays! Anyway, the car is just sitting for now. I'm waiting for the scanner.
Not always. Sometimes people come in and it's just a bulb replacement, done without a scanner.
Well, yes... it happens)

Since the problem affects several circuits on the left side at once (both the parking lights and the low beam), check the ground point of the left headlight and the common ground of the left side under the hood. On Rangers of this generation, the ground is often bolted to the body near the left headlight or on the left frame rail. Corrosion there produces exactly this picture: several lights on one side drop out at once. Clean the contact down to bare metal and treat it with graphite grease. It's worth doing this before bothering with the scanner. If the ground is the cause, the BCM errors may clear on their own after a few ignition cycles.