← Ford

Ford Kuga 2013 1.6 EcoBoost - rough starting, black smoke

Ford Kuga · 2013 14 answers Translated from Russian · original

Guys, can anyone who works on Ffords tell me the fuel pressure after the fuel pump, before the high-pressure fuel pump (HPFP)? It currently reads 5. The spark plugs are black, the engine starts unreliably and there is black smoke, so there is no power. I can't find the spec anywhere. I think it should be 3, but I'm not sure. Removing the tank is a real pain. The car is 4x4.

Answers
O
Owner Sep 08, 2020

What about the "high" pressure after the HPFP, in the fuel rail?

O
Owner Sep 24, 2020

They had a problem with HPFP pumps seizing, and the system going into limp mode on low pressure from the feed pump.

O
Owner Oct 20, 2020

Is there a fault code for the pump? What is the PWM? I dealt with something similar last winter. I recorded data and oscilloscope traces, so we can compare.

O
Owner Dec 07, 2020

5 is normal. The problem isn't there.

O
Owner Mar 31, 2021

The low pressure is secondary, really. What you need is the desired and actual high pressure, plus the % of the HPFP regulator. What are they?

O
Owner Aug 11, 2021

Is it turbo or not? If it's turbo, there could be a whole bunch of causes. Pistons break up, injectors leak, and so on. They don't last on our gasoline.

O
Owner Aug 29, 2021

Yes, it's turbo. For now we're checking the HPFP and the injectors. We don't want to dig deeper. We're looking for a way to test the HPFP.

O
Owner Sep 25, 2021

On the HPFP, the rod sticks out 22 mm. If it's 17 mm, it's seized.

O
Owner Oct 11, 2021

I've already googled all of this. There is a smell of gasoline from the oil. Fault code P2196, rich mixture. It's clear that either the HPFP or the injectors are leaking. We sorted out the pressure in the tank: 4 to 5 is normal. So for now it's the HPFP or the injectors. The rod presses in 22.5 mm from the flange. Either way, we should try replacing the HPFP first, then look at the injectors.

O
Owner Oct 26, 2021

Did you check the oil level? It's very rare for the injectors to make the oil smell of gasoline, especially when hot.

O
Owner Dec 10, 2021

The level is high. We're looking for a used HPFP.

O
Owner Mar 15, 2022

Sometimes the HPFP leaks gasoline into the oil. In that case, replace the HPFP and also change the engine oil. The HPFP is checked for fuel leaks by feeding it 4 to 6 atm of fuel and looking for a leak at the rod.

O
Owner Apr 28, 2022

That's exactly what we're doing. We removed the HPFP and are changing the oil. I asked about fuel pressure because the fuel pump currently gives 4 to 5. I thought it should be 3, but the manual says 4-5. They are tested at 5-6, as you wrote. We'll find a used one, fit it, and see.

O
Owner May 18, 2022

At 4-5 bar fed to the HPFP, it's practically impossible to find a leak. The rod seal leaks when it's hot and under high pressure.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →