Opel Astra J 2012 - Fault codes C0277 (07) and C0890 (07)
The car is a 2012 Astra J with the A16XER engine. I need a wiring diagram for the brake pedal position sensor, which has a 6-pin connector. The faults are C0277 (07), brake pedal position sensor circuit, and C0890 (07), control module 3 reference voltage output circuit. After these faults appeared, the brake lights stopped working.
Here you go, I've sent it to your e-mail. I couldn't find where the three wires go. They said something about them in training, but I don't remember. I'll look for it.
Thanks, but the point is that the brake pedal sensor has 6 pins, and the car has an automatic gearbox. I can't find a diagram for it. The diagram above is for a 3-pin sensor, so unfortunately it's not the right one.
Yes, I know. They talked about it in training, but that was a long time ago. Either the other pins aren't used, or they go somewhere, but they aren't in TIS. Supposedly it's a TIS omission. I can't find it in TIS.
Here's a diagram from the Mokka. The Astra J doesn't have this one, but it might work, since they share a platform. I sent it by e-mail.
Here's another one. Is the model year stated correctly? I sent you a diagram for the Astra J for the 2013 MY in a private message. I gave the second part in post #2.
Thanks, that's exactly what I needed. I'll fix the car and report back.
We've fixed the car. The topic is closed. The ground from the brake pedal sensor had been lost. It is the black wire with a brown stripe on pin 2, marked as wire A on the diagram. It goes to connector X1 pin 19 of the body control module (the white connector in the BCM). We ran a ground wire from BCM pin 19 to pin 2 of the brake pedal connector. The faults cleared and the brake lights work. I'll post photos tomorrow.