← Opel

Opel Vivaro 2008 M9R stalls

Opel Vivaro · 2008 7 answers Translated from Russian · original

This car is in for diagnostics today. The injectors are new. They were replaced because the piezo element was shorting to the housing, according to the engine repair shop. The wiring harness is new. The engine doesn't stall when cold. It warms up to about 60 degrees, and when the throttle is pressed to the floor, it stalls at about 3000 rpm. It restarts immediately with no problems. Screenshots attached. The engine stalls where I placed the marker. No signals drop out, all the way until the engine stops turning. The catalytic converter has been removed. I can't figure out what's going on. There are no fault codes. The software is stock.

Answers
O
Owner Aug 03, 2020

Where does the speed come from on a stationary car?

O
Owner Aug 16, 2020

That's in first gear. The car is moving.

O
Owner Sep 21, 2020

Has the low-pressure side been checked and found OK? Filter, air in the system? Maybe there simply isn't enough fuel at higher rpm?

O
Owner Dec 21, 2020

According to the sensor, high pressure is normal. In practice, I have no way to measure it while driving.

O
Owner Jan 23, 2022

I had this on a Touareg. There was no back pressure on the injector return line and the injectors stopped working. The valve was stuck open. It's just inconvenient to measure, you need an adapter.

O
Owner Mar 07, 2022

The injectors need to go on a test bench. A lot of Siemens piezo injectors come in for repair. Sometimes they leak or are faulty, and there are no fault codes.

O
Owner Apr 27, 2022

These symptoms can come from the pressure relief valve in the rail. I had a car like this not long ago. I replaced it and everything was resolved.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →