https://autopapyrus.com/catalog/haval/jolion/guides/dual-clutch-transmission-fluid-change/
Haval Jolion 1.5 Turbo (2023): Dual-Clutch Transmission Fluid Change
The exact procedure for this model is not documented in publicly available service materials, so the general principle for dual-clutch automated transmissions is given below. Check the capacity, fluid type and torque specs against the manufacturer's service schedule. The main difficulty is setting the fluid level correctly: on this transmission the level depends on fluid temperature, so an incorrect level is common even after service. Underfilling is dangerous for the transmission.
Parts
3| № | Part |
|---|---|
| 01 | 7-speed DCT transmission fluid, JolionFind on Amazon → |
| 02 | Transmission drain plug sealing washernewFind on Amazon → |
| 03 | Transmission fill/check plug sealing washernewFind on Amazon → |
Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.
Tools
9- Lift or inspection pit Amazon →
- wrenches and sockets for the plugs (check the size on the vehicle) Amazon →
- torque wrench Amazon →
- syringe or pump for filling the transmission Amazon →
- measuring container Amazon →
- drain pan Amazon →
- diagnostic scan tool that shows transmission fluid temperature Amazon →
- rags Amazon →
- new sealing washers for the plugs Amazon →
Read the codes yourself
A scanner plugged into the OBD2 port under the dashboard shows which fault codes the car has stored, before you buy any parts. Cars sold in the US from 1996, and petrol cars in Europe from 2001 (diesels from 2004), have this port.
- Basic code reader, about $20–40: reads and clears engine codes Amazon →
- Bluetooth scanner with a phone app, about $30–100: live sensor data, and on many cars ABS and airbag codes too Amazon →
Check that the scanner lists your make and model year before you buy. We may earn a commission from qualifying purchases.
Step by step
12 steps- Warm up the transmission with a short drive of 10-15 minutes, then park the vehicle on a level surface or lift, perfectly horizontal. Turn the ignition off.
- Remove the underbody skid plate if it blocks access to the transmission.
- Locate the drain plug and the check plug on the transmission housing. Wipe them and the area around them so dirt does not get inside.
- Place the drain pan and remove the drain plug. Drain the fluid completely and inspect it: dark color and fine suspended particles are acceptable, but large metal chips are a reason to have the transmission diagnosed.
- Measure the volume of the drained fluid so you can refill a comparable amount. Do not rely on a figure from memory; rely on the manufacturer's specification.
- If your version has an oil filter or screen on the transmission, replace or clean it according to the service schedule. Confirm whether a filter is present and where it is located when you inspect the unit.
- Install the drain plug with a new washer. Tighten to the manufacturer's torque spec; for plugs of this type it is usually 20-40 N·m (15-30 lb-ft). Do not overtighten, as the housing may be aluminum.
- Fill with new fluid through the fill or check hole using a syringe or pump, in the amount specified by the manufacturer.
- Connect the scan tool, start the engine, and use the scan tool to warm the transmission fluid to the temperature specified in the service schedule for checking the level. Cycle through the selector positions, pausing in each one.
- At the correct temperature, with the engine running, remove the check plug (if the procedure calls for it): a thin stream of fluid should seep out. If no fluid comes out, add more and repeat. If it flows out heavily, let the excess drain until it is a thin stream.
- Tighten the check plug with a new washer, within the same torque range. Check for leaks.
- Reinstall the skid plate, take a test drive, and afterward inspect the plugs for leaks. If necessary, reset the transmission adaptations with the scan tool.
Common mistakes and warnings
- This job requires an exact fluid level and control of its temperature: underfilling or overfilling leads to overheating, shuddering and clutch wear
- If you lack experience or a scan tool that shows transmission fluid temperature, go to a repair shop
- The fluid must strictly match the specification for this exact transmission; universal ATF and fluids for conventional automatic transmissions are not suitable
- Draining hot fluid can cause burns, so wear gloves
Spotted a mistake? Tell us →
Our articles
News
The Week in Cars: Li Auto Hacking, October Sales, the Monjaro Rumour and the 2027 Recycling Fee
Li Auto owners in Russia are having their car accounts hacked, and the car will not start without a ransom. Plus…
Read →
Before you buy
Used Haval Jolion: What Breaks and When — 5 Checks Before Buying
The Haval Jolion has no disastrous flaws, but plenty of small issues: what breaks before 100,000 km, a mileage scale…
Read →
Before you buy
Which Used Chinese Crossover to Buy: Haval Jolion, Chery Tiggo 7 Pro, Geely Coolray or Monjaro
Engine and gearbox life of four used Chinese crossovers and what to check before buying: the pre-2023 Coolray's timing…
Read →