← 2106-03

Lada 2106-03 (Gen. 1): Heater Motor Resistor Replacement

The resistor is wired in series with the heater blower motor and sets the lower fan speed. If it burns out, the fan may run on only one speed or may not start on low. The resistor is mounted on the heater housing under the dashboard. Access is the same as for replacing the heater blower motor.

DifficultyMedium Time1-2 hours Steps11

Diagram: where the heater series resistor is and how the wires connect to it

Inside the heater housing with the cover removedHeater housing1Series resistor2Terminals with connectors3Red wire to the fan4Fan impellerTap to enlarge
  1. 1Series resistor: a brown ceramic cylinder with two metal clamps on a plate. Test it and replace it with a new one.
  2. 2Resistor terminals with connectors: before removing, remember or photograph which wire is on which terminal, and reconnect the same way.
  3. 3The red wire runs from the electric fan to the series resistor.
  4. 4Heater electric fan: an impeller with a hub and five blades next to the resistor on the housing.

Part

№PartAlternatives
01 Heater motor resistor for VAZ-2106Find on Amazon → AlternativesDAAZAvtoelektrika

Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Tools

4

Step by step

11 steps
  1. Disconnect the negative battery terminal.
  2. Remove the dashboard shelf and the radio panel. You can't reach the heater without doing this.
  3. Remove the two screws and take off the lower air ducts.
  4. Find the red wire that runs from the blower motor to the resistor. The resistor is on the heater housing.
  5. Before disconnecting anything, memorize or photograph which wire goes to which resistor terminal.
  6. Pull the wires off the resistor terminals. If the resistor is held by a screw or nut, remove it. The exact type of fastener depends on the specific car.
  7. Test the old resistor. With a multimeter set to ohms, there should be continuity between the terminals. A burned-out resistor has none. A test lamp also works for this check.
  8. If the resistor is good but the fan still doesn't work correctly, check the heater switch on the dashboard. Remove it with a screwdriver and note the order of the wire connections. Also check the connections and ground of the motor: the ground wire attaches to a stud on the heater.
  9. Install the new resistor and connect the wires in exactly the same order as before. Secure the resistor the same way the old one was secured.
  10. Reconnect the negative battery terminal and check the fan on every switch position. If needed, only refit the temporarily removed parts at this point.
  11. Install the air ducts, radio panel and dashboard shelf in reverse order.

Common mistakes and warnings

  • Do all the work with the battery disconnected
  • The resistor gets very hot in operation, so don't leave it touching plastic or wires, and don't connect the wires in a different order
  • This can melt the wiring
  • Check the exact resistance values and fastener torque against the manufacturer's specifications
  • If you aren't confident working with electrical wiring, take the car to a repair shop
Spotted a mistake? Tell us →