← Hyundai

Hyundai Grandeur TG: correlation between the crankshaft and camshaft position sensors, bank 1

Hyundai Grandeur · 2006 10 answers Translated from Russian · original

Hello. 2006 Grandeur, 3.8 engine, automatic. It starts and runs with misfires. It responds normally to the pedal, and there are no misfires when revving up. They only happen when going to idle and at idle. Code 0016 is stored: crankshaft and camshaft position sensor correlation, bank 1. Swapping in the sensors from bank 2 changed nothing. The bank 1 timing marks are in place. I haven't looked at bank 2. On the bank 1 spark plugs there were several rings that pushed the plug up by 2-3 mm. I removed the extra rings. In the camshaft sensor data, the first one shows nothing at all. The camshaft sensor wire isn't broken, and the wires ring out to the ECU connector. The oil is fine and the level is full.

Answers
O
Owner Oct 25, 2021

Are the spark plugs resistor type? Is the signal coming from the sensor?

O
Owner Nov 06, 2021

Check the timing marks, the keyway slots and the variable valve timing coupling. The camshaft sensor marker may not be in the right place.

O
Owner Nov 16, 2021

As I understand it, the spark plugs have resistors, NGK IR. I can't see the signal from the scanner. What else can I use to look at the signal from the sensor?

O
Owner Dec 23, 2021

The signal from the sensor is present. I checked it with a tester with an LED. Would it work like this with a faulty phase coupling? Also, the actual phase position reads 0 on one side, and on the second one the phase position reading keeps changing.

O
Owner Mar 18, 2022

That's great that you have a device like that. The sensible approach is to capture the sync signal from all the timing sensors and compare it with a reference.

O
Owner Apr 12, 2022

The problem is that I don't have an oscilloscope. What should I do without one?

O
Owner May 01, 2022

1. Hand the car over to someone who has one. 2. Buy or find an oscilloscope. 3. Take everything apart and check the marks, any shift of the marker discs, the hydraulic couplings, chain stretch and so on.

O
Owner May 19, 2022

What was the thinking behind the spark plugs? Why were extra rings fitted?

O
Owner Jul 13, 2022

Were you trying to lower the compression ratio?

O
Owner Jul 20, 2022

The spark plugs have nothing to do with this code. If the plugs were causing interference, you would get errors on the sensor signals, but yours is a phase mismatch. In theory, though, some errors for the crankshaft and camshaft sensors may have been masked.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →