Hyundai Santa Fe: two glow plugs dead
Hyundai Santa Fe, 2007, diesel, manual gearbox, VIN KMHSH81WP80342517. This vehicle was towed to me on a rope, and I was given the backstory: the engine still started recently, but according to the owners it was running on three cylinders ("troit"). The car was then taken to the official dealer for diagnostics, and they said two glow plugs had died. After that the car was taken to some self-styled specialists, who flatly rejected the dealer's diagnosis, claiming this engine has no glow plugs. They also unscrewed the solenoid from the first injector. They saw nothing inside the solenoid and screwed it back on, and after that the car doesn't even try to start. Then the car was brought to me. I checked the glow plugs and two of them really did have to be replaced. - It does not start. I checked for fault codes with a Launch scanner - no codes. I unscrewed the solenoid of the first injector - there is no washer and no spring in it anymore. I moved the washer and spring over from the second injector - it still does not start. I connected an oscilloscope to the first injector - there are no pulses. I loosened the fuel line nuts at the injectors - the pressure from the high-pressure fuel pump is excellent. I assume the crankshaft position sensor is fine too, since the Launch shows engine speed when I crank it with the starter, and even the tachometer needle moves. Please help me fix it.
Funny pressure test. You should have written the actual numbers. This is a diesel! The injectors that were "repaired" will most likely have to be replaced and coded.
Is there no control signal only on the first injector, or on all of them? That is not clear at all... Is it not needed on the second injector?
What is the rail pressure?
They already said it - EXCELLENT.
Ah, right, it sprays like a jet. The Launch shows adequate data on this car, so give us the datastream data.
Until the required pressure is reached, neither the first nor the second nor ANY injector will spray, and there will be NO pulses to them. The injectors that were taken apart - as was correctly said, they will need replacing or parts (you will be practicing). Before getting into a car, first find out the price of the spare parts (if you knew how much an injector costs, you would hardly have rushed to take them apart without thinking).
Send the injectors for repair if there is a company that does this seriously, and give the pressure figure in the system.
Here the dealer charges from 14 to 28 for replacement (the cost).
They didn't take the whole injector apart, they only removed the solenoid. Which sensor do the ECU read the pressure from? And why would it stop the pulses?
If the repair was done with the ignition on (which you are not sure about), that is how it will be. Read all the posts with replies - you have already been answered. Give us the data.
Give the car to be repaired to people who work with these specifically. Taking injector solenoids apart like that will have consequences that hit the owner's budget very hard.