← Hyundai

Hyundai Matrix: I think the problem is in the mechanical valve

Hyundai Matrix 11 answers Translated from Russian · original

Hyundai Matrix 1.5CRDi Turbo Diesel stalls when revs go above 2500 rpm, both while driving and while stationary. I've checked everything and I think the problem is in the mechanical valve located in the rail. With the ignition on, diesel runs out of the rail return line in a stream. Can this valve be revived or replaced?

Answers
O
Owner Dec 01, 2020

An ultrasonic bath would help.

O
Owner Dec 14, 2020

I've already tried ultrasonic cleaning, and the Yoshkar-Ola "Nika" cleaner too.

O
Owner Jan 06, 2021

Then replace it. But you should also have looked at the calculated and actual pressure data from the scanner, at idle and while raising the revs until it stalls.

O
Owner Mar 23, 2021

How does it start? With the starter? Easily?

O
Owner Apr 19, 2021

Right, you need the rail pressure data, and you need to study the scanner readings at the moment of stalling. The rail pressure regulator is not closed when the ignition is switched on. It closes during cranking with the starter, when the signals from the crankshaft position sensor and the camshaft position sensor appear, and it is closed by a PWM signal. If the car starts easily, look at the readings. Check the EGR system too, and the intake throttle.

O
Owner May 12, 2021

Who diagnosed the car? What did they use?

O
Owner Oct 06, 2021

I had this problem! It turned out the whole problem was the injectors! The check valve in one of the injectors wasn't holding, and everything went into the return line! But you need to check and look at the parameters at the moment it stalls!!!!

O
Owner Dec 14, 2021

Of course I looked at the pressure at startup, while running, and at the moment of stalling. I suspect the ECU is shutting the engine down in an emergency because there isn't enough fuel pressure, in the same way as the Vito has protection for maximum and minimum pressure. Yes, the start isn't very good. A Common Rail engine usually starts better, but the starter cranks energetically. I checked all the signals with both a scanner and an oscilloscope. When the engine starts to die, it's unclear whether it's a pressure problem or the ECU protection kicked in, because the stalling happens at the same time. The owner also went to a specialist, where the fuel pressure regulator was replaced, which didn't help. They also went to a Bosch service, where the low-pressure pump was replaced. Honestly, I checked everything, but no luck. In case it matters, I looked with Bars, Launch and ELM327, and they all show the same.

O
Owner Jan 07, 2022

Like an anesthesiologist, I ran separate lines to each flask, but with the ignition on, the return flow only gushed from the rail. I even used a frequency generator to simulate closing the fuel pressure regulator (that is, I forced it closed), but the diesel still sprayed out.

O
Owner Mar 25, 2022

There's a safety valve on the rail, and it's the one leaking? Throw it in the trash!

O
Owner May 27, 2022

Thanks everyone! We installed a rail from a donor car and everything is fine now.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →