Hyundai Sonata (NF) 2008, radiator fan runs constantly
Hello all! I have a problem: the radiator fan ("Carlson") runs all the time. There are no fault codes. The fan control module (the one under the headlight) constantly receives 4.5 V. My first question: what voltage should it get so that the fan doesn't run? The car may have been reflashed. I deliberately flashed the stock firmware, going by the identifiers, but the problem didn't go away. ECU is SIM2K 141.
What do the parameters show?
If you mean the engine temperature parameters, they're normal. Even when the engine is cold, i.e. 18-20 degrees depending on the outside temperature, the fan comes on right away (5-7 seconds) after the ignition is switched on.
What about the refrigerant pressure? What outside temperature does it read? Is there a fan-on request from the climate control?
Well, if the fan can only come on because of that, then that's disappointing.
Terrible build quality, everything is held together with rivets and crude fixes, as they say about how aircraft were built! There is a request coming from the A/C, but the fan has kept spinning at one speed. What interests me more is what kind of signal controls the speed: its frequency and voltage. I've had an idea, and I'll check it tomorrow. If anyone has ideas, post them and I'll try them and report back.
Is the 4.5 V a constant voltage, or an average level measured with a tester?
Identifiers from the diagnostics, or the identifiers on the control unit? You need to write what is on the unit's label.
Right, it's PWM, and the control is done inside the unit. If you suspect it, disconnect it and check.