Unstable idle on Hyundai Lantra 1.5 L 8-valve 87 hp 1994
I need information, because there is almost nothing on this car. The idle hunts and jerks as soon as you start to move off. I checked the timing marks and the valve clearances (hot: intake 0.15, exhaust 0.25). Compression is 12. Fuel pressure is 3 bar. The coolant temperature sensor, throttle position sensor and camshaft position sensor are fine. The MAF is new, and so are the HT leads and spark plugs. The oxygen sensor responds normally. I checked the injectors on a test bench and they are fine. I set the ignition timing at roughly 10 degrees. The engine ground is fine. The secondary ignition checked fine on an oscilloscope. It feels like the engine isn't getting enough air. If you create an air leak, it runs more smoothly, but the revs go up. When the revs hunt, the vacuum is about 0.45 bar. With an air leak it is 0.70 bar. What should go to the idle air control valve (if I'm calling it the right thing)? At idle it has +2 V, ground and +8 V. With the ignition on, all three show ground. Point me to where else to look. If anyone has the ECU pinout, I'd be grateful.
Going by a Mitchell diagram, which isn't for this exact car but a similar one, pin 2 of the idle air control valve gets positive voltage when the ignition is on. Pins 1 and 3 are control signals from the ECU. Check that positive with a test lamp, not a voltmeter. It should show battery voltage and not sag.
What does the MAF show?
At idle it's about 1.5 V, if I remember correctly. I'll confirm tomorrow. Also, it says GM on it?!
My readings at idle are 0.9 - 1.1 V (±0.1 - 0.2 V).
If the revs are unstable, the airflow meter will show nonsense too. You should sort out the power supply to the idle air control valve first. At 0.65 bar vacuum, the MAF shows about 1.6 V. On the idle air control valve: pin 2 has +12 V supply; pins 1 and 3 show 7 and 9 V. The cause is most likely crankcase gases, which are smoking and choking the engine. If the owner agrees, I'll do the piston group work, then report back.
Thanks, everyone!