← Mitsubishi

Mitsubishi Outlander 2006 - airbag error codes

Mitsubishi Outlander · 2006 9 answers Translated from Russian · original

I have this vehicle in the shop: a 2006 Mitsubishi Outlander, VIN JMBXRCU5W6U001957. The driver's seat belt pretensioner squib was replaced several times and kept firing. A fault was then found in the connector under the driver's seat. The connector was corroded and sitting in water. The driver's seat was removed and the connector was replaced with a twisted splice sealed with heat-shrink tubing. The error before the replacement was 66 Driver Pretensioner Squib (the translation in the G-scan tab may be rough). While the connector was being replaced it broke, and a month or two passed while the customer looked for a replacement. After the connector was replaced, more errors appeared: 26 Driver Pretensioner Squib 1 and 56 Driver Pretensioner Squib Drive Circuit 1. Error 66 is gone. My question: does anyone have a decoding of the airbag error codes for Mitsubishi?

Answers
O
Owner Jan 29, 2020

This sounds like a fairy tale, a pretensioner firing because of a connector.

O
Owner Mar 05, 2020

I thought it was a fairy tale too. A photo of the place where that connector sat is coming. First, some background: the driver of this car went to pay for fuel at a gas station and, out of habit, locked the car with the alarm (it has something like an Alligator). A bang sounded in the cabin right away. He opened the door and found that the pretensioner squib had fired. It is mounted in the left pillar between the doors. The SRS light was of course on. The owner ordered a used pretensioner from a scrapyard and installed it. A couple of days later it happened again when he locked the car. Then once more. After that the car came to me. And the G-scan showed error 66. We pulled up the wiring diagram, and there is a connector under the driver's seat. It is not sealed, and it had also fallen into water. It oxidized and shorted and got wet.

O
Owner May 03, 2020

Are there any errors? Is the engine a GDI?

O
Owner Jul 04, 2020

The two lower errors come up because the seat is removed. The upper ones get erased and then come back. I sent it to your e-mail.

O
Owner Sep 02, 2020

A squib can't fire without voltage being applied to its filament. Somewhere a wire is lying against the squib.

O
Owner Sep 16, 2020

It isn't lying there anymore. I reconnected everything. Guys, I'm waiting for an answer about the errors.

O
Owner Sep 17, 2021

The voltage probably came from the door lock circuit. And not only toward the squib, maybe into the SRS unit itself too. The EMF of the lock solenoid.

O
Owner Mar 08, 2022

There is a very high chance of outside EMF coming through the green connector.

O
Owner Apr 15, 2022

I'm asking again. Maybe someone has a decoding of the airbag error codes lying around. The G-scan gives two-digit numbers and a very unclear translation. I also have a Delphi scanner, but it doesn't see Mitsubishi.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →