← Mitsubishi

Mitsubishi ASX 2L - fault code P061A

Mitsubishi ASX 12 answers Translated from Russian · original

A couple of months ago I had an ECU remap done on this car. Everything was fine. Now the code keeps appearing on long drives. I took it to the official dealer, and they said: "This is normal for them, the automatic transmission overheats." Translated from English, the code reads roughly like this: Compares the current torque signal calculated from the manifold absolute pressure sensor signal with the driver's demanded torque signal from the accelerator pedal position sensor. The difference between the actual torque signal and the demanded torque signal exceeds the set value. What can I check? Has anyone run into this?

Answers
O
Owner Oct 19, 2021

It looks like slipping in the automatic transmission.

O
Owner Oct 27, 2021

What automatic transmission? This code also shows up on manual cars. You'd have to check everything, from vacuum leaks to the catalytic converter, and it could be anything. I had a Ford 1.6 115 hp with this code. I tried everything and fixed nothing. Later the customer called and said he had fixed his car himself. Before bringing it to me he had changed the air filter and messed something up there, though I have no idea what you could mess up there.

O
Owner Nov 06, 2021

Put the stock tune back. The fault is in the tuning.

O
Owner Nov 16, 2021

Remember the first Armeev tunes on the Lancer X. The throttle body would also drop out there. It looks very similar.

O
Owner Dec 03, 2021

Call the customer in and put the stock tune back on for a while.

O
Owner Dec 23, 2021

He'll come in this week, and of course I'll start with the stock tune. It's Sanya's GMS tune, and I don't think anyone has had problems with it.

O
Owner Jan 02, 2022

This isn't normal for them. The tune has nothing to do with it.

O
Owner Feb 20, 2022

About 6 months ago a similar car came in with the same code, and everything was gone through. The cause turned out to be the following: the GB. The GB was flushed, the gaskets were replaced, and the pan was washed. Miraculously the car left and the code did not come back. At first we didn't see any connection with the GB.

O
Owner Mar 22, 2022

GB, as in the cylinder head?

O
Owner Apr 30, 2022

P061B - Internal Control Module Torque Calculation Performance. As I understand it, this is P061 (A, B...), Engine control internal torque performance, on cars with an AT. Ford's recommended fix is a seemingly paradoxical, silly one: disconnect the battery terminal, unplug the connectors from the PCM, unplug the connectors from ALL the sensors and actuators on the engine and AT, then plug everything back in. I did all this with a skeptical look, like, "sure, sure..." That was it! The problem was cured, the owner was happy and said the transmission started working much better (he had come in with some vague complaints about it). His problem appeared after he towed a trailer.

O
Owner Aug 12, 2022

Well, on a Ford anything is possible. I've had cases where I wrapped the ECU connectors in foil to drain any residual voltage, and it helped for a week, then everything came back. Here everything is normal: the AT oil hasn't been changed, the level is normal, and the mileage is only 30 thousand km. He's coming on Tuesday, and I'll put the stock tune back first, then we'll see.

O
Owner Dec 27, 2022

Actually, that was a completely different case, with codes P1238 and P1241.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →