← Mitsubishi

Won't start below -20 — Pajero 2, 6G74, 3500, 1997

Mitsubishi Pajero · 1997 8 answers Translated from Russian · original

I've owned it for three years, and every winter it's the same problem: it won't start in the cold. I change the fuel filters regularly, and the tank is clean. It cranks well, there are no fault codes, and fuel pressure at start-up is 3.5 bar. The temperature sensor in the MAF sensor shows the resistance given in the manual. It may start after 3 to 10 attempts, after cranking with the starter for 3 seconds. Once it has started, if I shut it off right away and start it again, it runs perfectly. I left it outside the garage to freeze and it wouldn't start. I pushed it into the garage (+12 degrees), it sat for 5 minutes and then it started. No scanner reads it. People say only MUT3 will.

Answers
O
Owner Dec 12, 2019

Why did you decide it should start in the cold? If the stock head unit isn't installed, no scanner will read it.

O
Owner Dec 17, 2019

Thanks for replying. That's a surprise. Where do you even find the stock one now? As for starting in the cold, this is a Pajero, not one of today's pampered crossovers. Did the Japanese really build in protection against starting in the cold back then? Although according to the documents, the car went from the factory straight to Germany, so maybe it has some software meant for warm countries. The question is how to solve this problem. Thanks in advance for any advice.

O
Owner Dec 22, 2019

SM2 will read it from cover to cover if it has an OBD connector.

O
Owner Jan 27, 2020

The K-line is convoluted on this car.

O
Owner Feb 08, 2020

You need a Carman Scan or another multi-brand scanner with a 12-pin Mitsubishi adapter. It should read this beast.

O
Owner Feb 18, 2020

Did you check the engine temperature sensor? Is there a starter-engaged signal at the ECM?

O
Owner Mar 02, 2020

When the car won't start, are there pulses to the injectors and a spark at the spark plugs? Is there a signal from the crankshaft sensor? You can check the injector pulses with an LED test light.

O
Owner May 07, 2020

There should already be an OBD connector. Engines like the 4D56 have had OBD since 1996, and VCS reads them fine.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →