← Mitsubishi

Mitsubishi Legnum 4G93 GDI - stalls once it warms up

Mitsubishi Legnum 8 answers Translated from Russian · original

It starts and runs when cold, but stalls once it warms up. When hot, it starts and runs for a few seconds. If I start it and press the gas, it stalls immediately. No error codes. Where should I look?

Answers
O
Owner Jun 16, 2020

The catalytic converter looks like it has fallen apart, or it could be an air leak and low fuel pressure.

O
Owner Jul 23, 2020

The catalytic converter is fine, I found no air leaks, I'll measure the pressure.

O
Owner Aug 25, 2020

The electronic throttle often fails on these. Remove the intake hose and see whether the throttle rotates when you press the gas pedal. Also, I forgot to say, check the fuel pressure. The scanner has a "fuel pressure" parameter.

O
Owner Nov 01, 2020

What is the pressure at the pump and at the pressure sensor on the high-pressure fuel pump?

O
Owner Jan 29, 2022

If you don't have a scanner, you can estimate the pressure by measuring the voltage from the pressure sensor on the pump (middle wire). With the engine running, the voltage should be about 3 volts, which corresponds approximately to a pressure of 4.8 MPa (about 50 kg/cm2).

O
Owner Feb 18, 2022

To start with, take out the screen filter at the high-pressure pump inlet, clean it in an ultrasonic bath and check the pressure, then write back. I've specialized in GDI engines for 6 years.

O
Owner Mar 18, 2022

Measure the fuel pressure (if it is a first-generation high-pressure pump, you will need a pressure gauge), check the injector driver, and replace the small filter at the high-pressure pump inlet.

O
Owner Apr 14, 2022

Thanks, everyone. The problem was the high-pressure pump. The topic can be closed.

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →