← Mitsubishi

Mitsubishi Chariot 1992 4G63 hard to start after sitting

Mitsubishi Chariot · 1992 10 answers Translated from Russian · original

Hello. I need your help. The problem: the engine starts poorly after sitting for more than 5 hours. With each use of the starter it catches a little more, and in the end it starts after about 20-40 tries. After that it starts perfectly all day. If I pour gasoline into the injector by force, it starts right away. After the engine starts, the check engine light comes on within 1-3 minutes. Codes: 13 - intake air temperature sensor, 14 - throttle position sensor (TPS), 21 - coolant temperature sensor, 25 - barometric pressure sensor. The car drives normally despite this. Anticipating some of the advice, here is what has been done: the air flow meter has been replaced, the TPS has been replaced, the coolant temperature sensor data is normal, the capacitors in the ECU were replaced about half a year ago, and the timing belt was replaced yesterday, with the marks aligned. Car details: MMC Chariot 1992, 4WD, 4G63 8-valve. Number: N43W-0006137. I would be glad of any advice. Thank you.

Answers
O
Owner Jan 08, 2021

Have you measured compression?

O
Owner Jan 16, 2021

Have you measured fuel pressure?

O
Owner Jan 31, 2021

By the symptoms, the fuel pump is dead. By the codes, the ECU is dying, even though something was replaced in it. PS: these cars should be put down by now, so they stop suffering and stop tormenting their owners and repairers.

O
Owner Feb 20, 2021

The engine ECU is faulty, possibly beyond repair...

O
Owner Mar 30, 2021

I have repaired ECU MD174845, and there is nothing serious about it. The board is two-layer. You definitely have corrosion. Test continuity of the line from each sensor pin that has an error through to the processor. The problem will be in the marked area. You need to test continuity, not just look with your eyes. Contact is lost under the SMD resistors. I drew a diagram of the supply voltages and the E310 wiring, but I did not find a diagram of the temperature sensor, TPS and VAF lines. Maybe I did not bother, because it is all simple there, 3 or 4 resistors. All the lines run right next to each other into the processor. A TPS error can occur if the idle switch is not closed with the pedal released. In that case, turn the sensor a little further. (PHOTO - something to be worked out)

O
Owner May 01, 2021

I had a similar case with the coolant temperature sensor. Before starting, it showed +150 °C! After starting with the coolant temperature sensor disconnected and then reconnecting it a minute later, it showed the temperature normally, and stayed that way until the next morning. During the day it started normally.

O
Owner Jul 07, 2021

I had not thought of measuring compression. The engine was rebuilt a year ago, so I did not think of it. Thank you very much for the photo. I will remove it and look on Sunday (a neighbor used to repair televisions, he may help). The TPS has been adjusted. (for the photo) The coolant temperature sensor was replaced, but nothing changed. Thank you all very much. I will check everything. I will post the results.

O
Owner Mar 13, 2022

Are you the car owner or a mechanic?

O
Owner May 05, 2022

The owner. Does that change anything?

O
Owner Jun 11, 2022

I found it by accident, it was in a folder of drawings. Maybe it is still relevant. (sent privately)

This discussion took place in the Russian-language Autopapyrus community and was translated automatically; owners' names are left out. Asking and answering on autopapyrus.com opens soon. Need step-by-step instructions now? Build a guide for your car →