← Cybertruck

Tesla Cybertruck (2024): Cabin Air Filter (HEPA) Replacement

The Cybertruck cabin air filter is located in the front trunk (frunk) behind a trim panel. It is replaced by hand with almost no tools. Follow the replacement interval shown under "Service Interval" in the vehicle menu. As a general guideline, in humid climates and dusty areas replace it at least once a year; in dry, cold climates, once every two years is acceptable. Signs it needs replacing: a musty smell and weak airflow from the vents.

DifficultyEasy Time10-15 minutes Steps14

Key figures

  • Filter cover bolts (if present)remove them in step 4; many vehicles do not have them
    2 pcs., 8 mm socket
  • Arrows on the new filterthis is how the filter is installed in step 9
    point up

Check these values against the manufacturer’s specification for your vehicle before you start.

Part

№PartAlternatives
01 Cybertruck HEPA cabin air filter with activated carbon, about 6 cm (2.4 in) thickFind on Amazon → AlternativesTeslaEVBaseBasenor

Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Tools

2
  • plastic trim removal tool Amazon →
  • an 8 mm socket is needed only if the filter cover is held by two bolts (not present on all vehicles) Amazon →

Step by step

14 steps
  1. Turn off the climate control system on the vehicle's screen.
  2. Open the front trunk (frunk) using the button on the screen.
  3. Pry off the trim panel with the Cybertruck logo by its edges, using your fingers or a plastic trim tool. It is held by friction clips and comes off with a light tug. Do not break the clips.
  4. Check whether the filter cover has two 8 mm bolts. If it does, remove them. If not, go to the next step.
  5. Press the upper latches on the filter cover and tilt the cover upward. The latches are fragile: push them up, not down.
  6. Before removing the old filter, note the airflow direction shown by the arrows on it.
  7. Slide the old filter straight out of the opening toward you.
  8. Wipe the seat with a dry rag and remove dust, leaves and debris so air can flow freely.
  9. Insert the new filter into the cavity with the arrows pointing up, as on the Tesla original. It should seat firmly, without tilting.
  10. Align the lower notches of the cover and press until the upper latches snap into place (you will hear and feel a click). Reinstall the 8 mm bolts if there were any. No torque specification is given: tighten only until snug, without force, to avoid stripping the plastic.
  11. Install the trim panel and make sure all the clips are seated.
  12. Close the frunk.
  13. Reset the cabin air filter service counter in the service summary in the vehicle menu.
  14. Turn on the ventilation and check the airflow and that there are no unusual noises.

Common mistakes and warnings

  • Do not install the filter against the airflow arrows: filtration efficiency will drop and airflow to the vents will be reduced
  • Do not force the fragile cover latches
  • If the cover or panel is damaged, replace it, otherwise unfiltered air will enter the cabin
Spotted a mistake? Tell us →

Our articles

More articles →