← Cybertruck

Tesla Cybertruck (2024): Wiper Blade Replacement

The Cybertruck has one large wiper blade that attaches to the arm with a locking clip and connects to the washer hose. Replace it at least once a year, or right away if the rubber is cracked, torn, or rough. You can do the job by hand, with no tools and without removing the arm.

DifficultyEasy Time10 minutes Steps10 ToolsNone required (you will need a soft towel)

Key figures

  • Blade replacement interval
    at least once a year. Rubber wear reduces visibility and camera performance (see Summary, steps 1-10)
  • Washer reservoir capacity
    4.2 L (4.4 qt). Useful when you top off the fluid after the check in step 10

Check these values against the manufacturer’s specification for your vehicle before you start.

Part

№Part
01 Cybertruck windshield wiper blade (wide, with washer fluid feed port)1 pcFind on Amazon →

Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Step by step

10 steps
  1. Put the vehicle in Park and turn the wipers off. The setting must be "Off," not "Auto." In "Auto" mode, the blade may start moving when it detects liquid on the glass.
  2. Lay a towel between the wiper arm and the windshield so you don't scratch or crack the glass.
  3. Lift the arm a short distance off the glass, only far enough to reach the blade. The arm doesn't lock in the raised position, so hold it by hand and don't lift it past its normal service position.
  4. While holding the arm, press the locking clip and slide the blade away from the arm. Set the blade down next to the arm.
  5. Pull the washer hose off the fitting on the old blade.
  6. Push the washer hose onto the fitting on the new blade.
  7. Line up the new blade with the arm and slide it toward the base of the arm until it locks. You should hear and feel a click.
  8. Gently pull and push on the blade to check that it sits tight and doesn't wobble. If there was no click, the blade can come off during operation and cause serious damage.
  9. Remove the towel and carefully lower the blade onto the glass. Don't let the arm drop onto the windshield.
  10. Test the operation: turn on the washer and the wipers. Fluid should spray from the nozzles on the blade. If there's no fluid, check the level in the reservoir. Then check the hose between the arm and the blade for kinks, leaks, and loose connections.

Common mistakes and warnings

  • Install only a blade identical to the original
  • The wrong blade can damage the wiper drive and the glass
  • Don't run the washer while washing the vehicle
  • A worn blade reduces visibility for the windshield cameras, so driver-assistance features may become unavailable or perform worse
  • Clean the blade with washer fluid or a non-abrasive cleaner made for automotive glass and rubber
Spotted a mistake? Tell us →

Our articles

More articles →