Autopapyrus · Tesla Model Y (2022)
https://autopapyrus.com/catalog/tesla/model-y/guides/low-voltage-battery-replacement/
https://autopapyrus.com/catalog/tesla/model-y/guides/low-voltage-battery-replacement/
Compiled automatically from service literature and owner experience. Specs are for the typical configuration — check them against your exact car before you start.
Tesla Model Y (2022): Low-Voltage Battery Replacement
The low-voltage battery powers the electronics, locks, windows and screen when the high-voltage battery is disconnected. Replace it when it is discharged or when warnings appear on the screen. The work is done under the front trunk (frunk), and you do not need to open the high-voltage circuit. This guide covers the lead-acid battery. Some Model Y vehicles came with a lithium-ion battery, so check the type first.
Key figures
- New battery voltage before installationcheck with a multimeter, charge at 12.4-12.6 V, do not install below 12.4 V (step 2)above 12.6 V
- Terminal nut and battery hold-down nut torque10 mm socket with a torque wrench, do not overtighten (steps 17, 19, 20)6 N·m (4.4 lb-ft)
- HEPA filter screw and washer coupling torqueonly if a filter is installed (step 23)5 N·m (3.7 lb-ft)
- Socket size for all nutsdeep socket, needed in steps 6-1310 mm
- Battery weightlift carefully, standing in front of the vehicle (step 14)about 12 kg (26 lb)
Check these values against the manufacturer’s specification for your vehicle before you start.
Part
| № | Part | Alternatives |
|---|---|---|
| 01 | 12 V, 45 Ah lead-acid low-voltage battery, red positive terminal coverFactory fit in North America: AtlasBX/Hankook, weight about 12 kg (26 lb); lithium-ion low-voltage battery if so equippedFind on Amazon → | AlternativesAtlasBXHankook |
Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.
Tools
8Step by step
26 steps · 5 stagesStage 1 of 5 Preparation 4 steps
- Determine the battery type on the screen: Controls > Software > Additional Vehicle Information. If it is a lithium-ion battery, the procedure is different (different mounting, and the new battery must be registered in service mode).
- Test the new battery with a multimeter. Its resting voltage should be above 12.6 V. At 12.4-12.6 V, charge it first. Do not install a battery below 12.4 V.
- Put the vehicle in park (P) and unplug the charging cable. Lower all the windows and leave one door open. After power is disconnected, closed doors may not open, and closed windows can be damaged when a door is opened.
- Put on gloves and safety glasses. Open the frunk.
Stage 2 of 5 Accessing the battery 3 steps
- Remove the rear underhood apron. Pry up the clips with a thin screwdriver or by hand and set the panel aside.
- If a HEPA filter is installed, remove the bolt on the washer fluid reservoir coupling (10 mm socket) and pull out the coupling. You do not need to disconnect the hose. A little fluid may leak out.
- Remove the two HEPA filter screws (10 mm socket). Lift the rear edge of the filter over the brake fluid reservoir and take the filter out.
Stage 3 of 5 Disconnection and removal 8 steps
- On the screen, select Controls > Safety > Power Off to turn the vehicle off.
- Loosen the negative terminal nut (10 mm socket) and remove the terminal from the post.
- Disconnect the emergency loop: slide the red lock toward you, then press the black latch.
- Remove the positive terminal cover (10 mm socket). Loosen the positive terminal nut, remove the terminal and cover it with a dry cloth. The positive terminal must not touch the battery bracket or the A/C lines.
- Disconnect the vent tube from the battery.
- Loosen the battery hold-down nut (10 mm socket), move the strap aside and, if necessary, tilt the hold-down back.
- Grab the handle and lift out the battery (about 12 kg (26 lb)). Stand in front of the vehicle and lift with your legs, not your back.
- If the new battery does not have a red contact on the positive side, transfer it from the old battery.
Stage 4 of 5 Installation 6 steps
- Set the new battery in place without bumping nearby parts and lines.
- Install the hold-down and tighten its nut to 6 N·m (4.4 lb-ft).
- Connect the emergency loop.
- Remove the protective caps from the new battery's posts. Install the positive terminal and tighten its nut to 6 N·m (4.4 lb-ft), then install the positive terminal cover.
- Install the negative terminal and tighten its nut to 6 N·m (4.4 lb-ft).
- Connect the vent tube.
Stage 5 of 5 Restoration and check 5 steps
- Open a door so the power restarts. The screen may take a few minutes to turn on.
- Install the HEPA filter, if there was one. Tighten the two filter screws to 5 N·m (3.7 lb-ft). Make sure the washer coupling's O-ring is in place, insert the coupling and secure it with its bolt, tightening it to 5 N·m (3.7 lb-ft).
- Install the apron, pressing until the clips click.
- If you installed a battery from a different manufacturer than the original (Clarios/Varta instead of AtlasBX, or the reverse), you need software version 2023.32 or newer. Then, in service mode, open Low Voltage > Power Distribution > Change Battery Type, select the installed type and press "Change Battery Type to Selected." This requires access to service mode, which Tesla and specialized repair shops have. If you install the same battery type, this step is not needed.
- Close the frunk and check that the battery replacement warning on the screen has disappeared and that the windows, locks and screen work. Transport the old battery upright and take it to a recycling drop-off point.
Common mistakes and warnings
- A lead-acid battery is heavy and contains acid
- Wear glasses and gloves, and do not let a tool short the terminals
- Do not touch or disconnect the high-voltage orange cables
- If you lack experience or are unsure about a lithium-ion battery, leave the work to a repair shop
- Install only a battery of the same type: a non-matching battery may not be covered by the warranty
Spotted a mistake? Tell us →
Our articles
Brand stories
The History of the Tesla Brand
Tesla Motors, a North American company founded in 2003, is rightly considered the pioneer of a new era in the…
Read →
Garage
Fuel Quality Indicators: What Octane and Cetane Numbers Mean
What is an octane number? What about a cetane number? Which fuel should you choose for a high-compression engine?…
Read →
Before you buy
How to Pick Up Your Car from the Dealership the Right Way
If you've decided to buy a car from a dealership, it isn't enough to simply choose a model you like, pay for it, and…
Read →