Autopapyrus · Tesla Model S (2018)
https://autopapyrus.com/catalog/tesla/model-s/guides/jacking-up-and-rotating-the-wheels/
https://autopapyrus.com/catalog/tesla/model-s/guides/jacking-up-and-rotating-the-wheels/
Compiled automatically from service literature and owner experience. Specs are for the typical configuration — check them against your exact car before you start.
Tesla Model S (2018): Jacking Up and Rotating the Wheels
The Model S has air suspension that automatically levels the body. For this reason, you must activate Jack Mode before lifting, or the vehicle may be damaged. This guide covers lifting with a floor jack and rotating the wheels. The lug nut torque is 175 N·m (129 lb-ft).
Key figures
- Lug nut torque175 N·m (129 lb-ft). Set it on the torque wrench in step 21 and tighten in a star pattern once the wheel is on the ground
- Number of lug nuts per wheel5. Remove and tighten all of them, starting with the bottom one (steps 14 and 18)
Check these values against the manufacturer’s specification for your vehicle before you start.
Diagram: where to put the jack and jack stand and what the removed wheel looks like
Tap to enlarge
- 1Rubber or polyurethane jack pad. Insert it into the middle of the three holes of the jacking point just behind the front wheel until it sits tight without rocking.
- 2Floor jack. Place it under the jacking point and raise the car smoothly until the wheel leaves the ground. Never work under a car held only by the jack.
- 3Hub with five lug nuts. While the wheel is on the ground, loosen the nuts half a turn, then remove them and take off the wheel. Start tightening from the bottom nut, tighten in a cross pattern, and finish with a torque wrench at 175 Nm.
- 4Jack stand. Place it next to the jack, in the adjacent jacking point: it is between the wheels, right in front of the rear wheel.
- 5Brake disc and caliper. With the wheel off, clean the hub mounting surface and inspect the disc.
- 6Wheel chock under a wheel that stays on the ground.
Part
| № | Part |
|---|---|
| 01 | Wheel lug nut capsif worn, when wheels were removedFind on Amazon → |
Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.
Tools
6Step by step
26 steps · 6 stagesStage 1 of 6 Preparation 6 steps
- Park the vehicle on a level, hard surface, shift into P, and turn the vehicle off. Do not jack it up on hot asphalt or on soft ground, because the jack may sink in.
- Unplug the charging cable, even if the car is not charging.
- Place wheel chocks under the wheels that stay on the ground.
- Decide on the rotation pattern. If the front and rear tires and wheels are the same size, you can swap wheels between axles. If the sizes are different, wheels can only be swapped left to right on the same axle. Directional tires (with an arrow on the sidewall) must not be switched to the opposite side without remounting them on the wheel.
- Mark the position of each wheel with chalk (FL, FR, RL, RR).
- Remove the lug nut caps, if equipped.
Stage 2 of 6 Jacking mode 2 steps
- Press the brake pedal and, on the touchscreen, select Controls, Suspension, then the highest ride height (Very High). Wait for the body to rise.
- On the screen, select Controls, Service, Suspension, Jack Mode. Without this, the air suspension will try to level the body during lifting.
Stage 3 of 6 Lifting 5 steps
- Locate the jack points: there are four, one at each wheel. The front ones are just behind the front wheels, and the rear ones are just ahead of the rear wheels. Lift only at these points. Do not place the jack under the battery or the side structural members.
- Insert the rubber or polyurethane pad into the jack point socket until it is seated firmly with no wobble. On the Model S, the jack point has three holes, and the pad goes in the middle one.
- Loosen the lug nuts by 1/2 turn on the wheel you will start with while it is still on the ground. Do not remove them completely.
- Position the jack under the jack point and smoothly raise the vehicle until the wheel is off the ground.
- Place a jack stand under the body next to the jack, at the adjacent jack point. Do not work under the vehicle, and do not leave it supported by only a jack.
Stage 4 of 6 Removal and rotation 4 steps
- Remove the 5 lug nuts and take the wheel off the hub, supporting it as you do.
- Repeat steps 9-14 for the other wheels that need to be rotated. It is safer to lift and swap the wheels one at a time.
- Clean the hub mounting surface of dirt and corrosion, and inspect the tires and brake rotors.
- Mount the wheel onto the hub in its new position.
Stage 5 of 6 Installation and tightening 6 steps
- Thread on the 5 lug nuts by hand, starting with the bottom one.
- Snug the nuts in a star pattern so the wheel seats evenly on the hub.
- Lower the vehicle until the tire touches the ground and the suspension begins to take load. Make sure the vehicle has not slipped off the jack.
- Using a torque wrench, tighten the 5 lug nuts in a star pattern to 175 N·m (129 lb-ft).
- Install the caps on the nuts. Fully lower the vehicle and remove the jack and jack stands.
- Repeat for the remaining wheels.
Stage 6 of 6 Finishing up 3 steps
- On the screen, select Controls, Service, Suspension, Disable Jack Mode. Return the suspension to the desired ride height.
- Check the tire pressure against the label on the door pillar, and reset or update the pressure sensor data if the system shows a warning.
- After 50-100 miles (80-160 km) of driving, recheck the lug nut torque.
Common mistakes and warnings
- Do not lift the vehicle without Jack Mode or at points not designed for lifting: this can damage the battery and body
- Never work under a vehicle supported only by a jack
- Incorrect seating of the pad in the jack point can damage the underbody
- If you have no experience with air suspension, have a repair shop do the lifting
Spotted a mistake? Tell us →
Our articles
Brand stories
The History of the Tesla Brand
Tesla Motors, a North American company founded in 2003, is rightly considered the pioneer of a new era in the…
Read →
Garage
Fuel Quality Indicators: What Octane and Cetane Numbers Mean
What is an octane number? What about a cetane number? Which fuel should you choose for a high-compression engine?…
Read →
Before you buy
How to Pick Up Your Car from the Dealership the Right Way
If you've decided to buy a car from a dealership, it isn't enough to simply choose a model you like, pay for it, and…
Read →