Autopapyrus · Tesla Model S (2018)
https://autopapyrus.com/catalog/tesla/model-s/guides/opening-the-car-with-a-dead-low-voltage-battery/
https://autopapyrus.com/catalog/tesla/model-s/guides/opening-the-car-with-a-dead-low-voltage-battery/
Compiled automatically from service literature and owner experience. Specs are for the typical configuration — check them against your exact car before you start.
Tesla Model S (2018): Opening the Car with a Dead Low-Voltage Battery
The Model S has no mechanical way to open the doors from outside when the 12 V battery is dead. First, supply power from an external source through the terminals under the service panel of the hood. With no power, the hood itself is opened using cable pull loops accessed through the wheel arches. This guide covers reviving the front of the car and getting into the cabin. If the traction battery is also fully drained, you will need to charge it at a charging station.
Part
| № | Part |
|---|---|
| 01 | Low-voltage (12 V) battery for Tesla Model Sif the jump start attempt fails; replace right away if the old one is old or deeply dischargedFind on Amazon → |
Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.
Tools
4Step by step
23 steps · 6 stagesStage 1 of 6 Preparation 2 steps
- Park the car on a level surface and make sure there is room nearby to open the hood. Get a portable 12 V power source ready and check that the cables are intact.
- Keep two restrictions in mind. The Model S must not be used as a donor to jump-start another vehicle. Never short the cables to each other or connect them to unrelated points.
Stage 2 of 6 Opening the hood without power 4 steps
- Carefully pry off the trim covers (fairings) in front of the front wheels with the plastic trim tool. They sit in a recess in front of each wheel arch.
- Behind the covers, find the pull loops (tabs) for the two hood latches. On cars built after 2016, they are located there.
- Pull both loops, then lift the hood. Use moderate force. If a cable has broken, the latch will have to be released with manual access from underneath. This is done at a body shop.
- Secure the hood in the open position.
Stage 3 of 6 Accessing the terminals 3 steps
- Remove the plastic service panel between the front trunk and the windshield. Pull it upward to release the clips.
- On top of the low-voltage battery, lift the connector lock.
- Pull the connector housing to the left. The connector will disconnect from the battery.
Stage 4 of 6 Supplying power 5 steps
- Open the cover of the red positive (+) jump-start terminal.
- Connect the red (+) cable of the power source to this terminal. Do not let the positive cable touch the body metal or any other parts.
- Connect the black negative (-) cable to the ground point in front of the low-voltage battery. This is the point indicated in Tesla's Model S manual.
- Turn on the external power source according to its instructions.
- Touch the touchscreen to wake up the system. The car may need a few minutes to gather enough power to wake the screen.
Stage 5 of 6 Entering the cabin and starting 3 steps
- Once the system wakes up, open the car the usual way. Use the key fob or the door handles.
- If power is not coming through and you still need to get into the cabin, enter through a front door. From the inside, the front doors of all Teslas open with a mechanical handle in front of the window switch panel. For the rear doors of the Model S, there is a cutout in the carpet under the seat. Move it aside to expose the tabs you pull to open the door.
- Get into the car and check that the system is ready to drive.
Stage 6 of 6 Finishing up 6 steps
- When external power is no longer needed, disconnect both cables. Start with the black negative (-).
- Close the cover of the positive terminal.
- Put the connector housing back on the battery so the connector engages. Press the lock down.
- Reinstall the service panel, pressing it down until the clips lock.
- Close the hood.
- Check the condition of the 12 V battery. If the discharge happens again, replace it. After a deep discharge, the car's systems sometimes do not start right away. The screen may stay dark. In that case, disconnecting the low-voltage battery for about a day and then reconnecting it helps.
Common mistakes and warnings
- Observe polarity when connecting the cables
- A mistake can damage the car's electronics
- If you have no experience with automotive electrical systems, or the hood will not open, contact a Tesla service center
Spotted a mistake? Tell us →
Our articles
Brand stories
The History of the Tesla Brand
Tesla Motors, a North American company founded in 2003, is rightly considered the pioneer of a new era in the…
Read →
Garage
Fuel Quality Indicators: What Octane and Cetane Numbers Mean
What is an octane number? What about a cetane number? Which fuel should you choose for a high-compression engine?…
Read →
Before you buy
How to Pick Up Your Car from the Dealership the Right Way
If you've decided to buy a car from a dealership, it isn't enough to simply choose a model you like, pay for it, and…
Read →