← Model S

Tesla Model S (2018): Cabin Air Filter Replacement

The Model S cabin air filter sits in the HVAC module on the front passenger side and keeps dust, pollen and exhaust particles out of the cabin. Tesla recommends replacing it every 2 years. In dry, dusty conditions or heavy city pollution, replace it every year. This guide covers the most common setup: a filter accessed from the right footwell. If your car has a separate HEPA unit, the procedure is similar, but access is from the left side, and the cover must be snapped in along the guides.

DifficultyEasy Time20-30 minutes Steps15 ToolsNone required (a plastic trim tool may help for gently pulling back the trim)

Key figures

  • Filter replacement interval
    2 years. This is how often Tesla recommends replacing the filter. After replacement, reset the counter on the screen (step 14)
  • Trim panel retention
    3 magnets. The footwell trim panel is held by them. When installing, press the panel in so that all three seat (step 12)
  • Filter arrow direction
    toward the rear of the vehicle. Install the new filter this way (steps 7 and 9)

Check these values against the manufacturer’s specification for your vehicle before you start.

Part

№Part
01 Cabin air filter for Tesla Model S 2012+ (activated carbon or HEPA)1 pc.Find on Amazon →

Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Step by step

15 steps · 4 stages
Stage 1 of 4 Preparation 3 steps
  1. Park the vehicle and turn off the climate control on the touchscreen.
  2. Slide the right front seat all the way back to free up the footwell.
  3. Get access to the panel in the passenger footwell and make sure the new filter matches the old one in size and type.
Stage 2 of 4 Removing the old filter 5 steps
  1. Slowly and carefully pull the lower footwell trim panel down. It is held by three magnets. Pull straight down, not at an angle.
  2. Disconnect the wiring harness electrical connector on the right side of the panel and set the panel aside.
  3. Squeeze the filter cover latch, remove the cover and set it aside.
  4. Note the airflow direction shown by the arrows on the filter: the arrows point toward the rear of the vehicle.
  5. Slide the old filter out of the HVAC module. Inspect the housing and remove debris and leaves with a dry rag or a vacuum.
Stage 3 of 4 Installing the new filter 2 steps
  1. Insert the new filter into the module with the arrows pointing toward the rear of the vehicle. The filter must sit flat, without tilting.
  2. Place the filter cover onto the module and press until it clicks. Make sure the latch is fully locked and the cover is tight. Otherwise, air will bypass the filter.
Stage 4 of 4 Reassembly and check 5 steps
  1. Bring the footwell trim panel up and connect the wiring harness electrical connector.
  2. Press the panel in so that all three magnets seat.
  3. Return the seat to its original position.
  4. On the touchscreen, in the Maintenance Summary, reset the cabin air filter replacement interval.
  5. Run the fan at different speeds. There should be no unusual noises, and the airflow should be even.

Common mistakes and warnings

  • A filter installed with the arrows in the wrong direction traps dust less effectively and clogs faster
  • Do not yank the footwell trim panel or pull it at an angle
  • You could tear off the harness connector or break the clips
  • Connect the connector before pressing the panel onto the magnets
Spotted a mistake? Tell us →

Our articles

More articles →