← Model X

Tesla Model X (2019): Checking Traction Battery Condition When Buying

On a first-generation Model X (2019), the condition of the traction battery largely determines the price of the vehicle. It comes down to remaining capacity, charging speed, charging history, the absence of battery management system faults, and warranty status. The check runs from the paperwork, to the range shown on the screen, to a charging test and an underbody inspection.

DifficultyMedium Time1-2 hours Steps20

Key figures

  • Minimum warranty capacity
    70% of original. Below this level, capacity loss is covered by the Tesla warranty (step 4)
  • Battery warranty term
    8 years. For a 2019 vehicle it ends around 2027 (step 4)
  • Normal wear per 100,000 miles
    about 5%. Anything noticeably higher (about 10% and up) is considered high wear and a reason to negotiate (step 8)

Check these values against the manufacturer’s specification for your vehicle before you start.

Part

№Part
01 None required. This is an inspection and diagnostic procedure. Do not open or repair the traction battery yourselfFind on Amazon →

Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Tools

4
  • smartphone for photos and recording readings Amazon →
  • OBD diagnostic adapter with an app that reads battery data (optional) Amazon →
  • flashlight Amazon →
  • charging cable or access to a charging station Amazon →

Read the codes yourself

A scanner plugged into the OBD2 port under the dashboard shows which fault codes the car has stored, before you buy any parts. Cars sold in the US from 1996, and petrol cars in Europe from 2001 (diesels from 2004), have this port.

  • Basic code reader, about $20–40: reads and clears engine codes Amazon →
  • Bluetooth scanner with a phone app, about $30–100: live sensor data, and on many cars ABS and airbag codes too Amazon →

Check that the scanner lists your make and model year before you buy. We may earn a commission from qualifying purchases.

Step by step

20 steps · 4 stages
Stage 1 of 4 Documents and history 5 steps
  1. Ask the seller for the exact trim (battery and motor configuration) and the build date. Remaining capacity is judged against the original rated range for that specific trim.
  2. Request the service and repair history: battery or module replacement, accidents, underbody impacts, flooding. A battery replaced under warranty does not mean there are problems, but confirm that the new pack is documented.
  3. Find out how the car was charged. Frequent fast charging and regularly charging to 100% speed up wear. Low mileage combined with a hot climate also matters.
  4. Check the battery warranty. According to Tesla, following the 2020 update to the terms, the warranty covers capacity loss below 70% for 8 years and within a mileage limit of 100,000-150,000 miles, depending on the model. For a 2019 vehicle, the term ends around 2027. Confirm the mileage limit in the service booklet or with Tesla.
  5. Check whether the car has any service restrictions or locks. Make sure the car is not registered as rebuilt after a total loss (salvage title).
Stage 2 of 4 Checking range on the screen 5 steps
  1. Ask the seller to charge the car to 90-100% before the inspection. Do not do it for them on the day of the deal without their consent, since an unnecessary full charge is bad for the battery.
  2. Turn on the car and, in the battery settings on the screen, compare the displayed range with the rated value for this trim. A loss of 0-10% is normal even for young vehicles, and a larger loss means wear.
  3. Wear benchmarks. According to Electrek, Teslas lose about 5% of capacity on average after roughly 100,000 miles, and 10% at that mileage is already a lot. After 320,000 km, Tesla cites an estimate of about 12% for the Model S and Model X. In the past, the 90 kWh versions wore faster than the 85 kWh ones, but a 2019 vehicle has newer cells.
  4. Take a photo of the screen showing the range, mileage and state of charge percentage. This will help with negotiating and with comparing against other vehicles.
  5. Review any error messages on the screen: warnings about the battery, reduced power or limited charging. Any such message is a reason to stop the purchase until the cause is found.
Stage 3 of 4 Charging test and driving 5 steps
  1. Connect the car to a home charger or an AC charging station. Make sure the port and connector are undamaged, the latch works, and charging starts without faults.
  2. If possible, test DC fast charging at a station. Power should ramp up to the value typical for this trim and should not drop sharply for no reason. A much lower speed with a warm battery points to problems.
  3. If the seller agrees, run the battery health test from the car's menu. According to the Tesla manual, it requires being plugged in to charge for a long time, so it needs to be set up in advance rather than done during a short viewing.
  4. Take a 20-30 minute test drive that includes hard acceleration. Watch that power is stable, there are no dips when you press the pedal and no power limits, and that the range drops evenly.
  5. After the drive, compare the drop in charge percentage with the distance covered. A sudden jump in percentage and power sag point to cell imbalance or wear.
Stage 4 of 4 Diagnostics and inspection 5 steps
  1. Connect a diagnostic adapter with an app that shows battery data. Look at remaining capacity, voltage spread across the cell blocks, and temperature. A large voltage spread between blocks is a sign of faulty cells.
  2. Inspect the underbody on a lift or in a pit. Look for dents and impact marks on the battery shield, signs of corrosion, coolant leaks and damaged connectors. A flashlight is a must.
  3. Check the battery coolant level in the reservoir. Unexplained coolant loss means a leak in the battery cooling loop.
  4. Check that the A/C and battery cooling work correctly: after the drive, the fans and pump should run without noise.
  5. Put it all together: documents, screen readings, charging speed, diagnostic data and inspection. If anything doesn't add up or the seller refuses a check, walk away from the purchase.

Common mistakes and warnings

  • The traction battery operates at high voltage, which can be fatal
  • Do not open the battery, do not disconnect the orange high-voltage cables and do not remove the underbody shield
  • All work on the high-voltage system must be done only at a specialized shop with insulated tools and 1000 V gloves
  • If you have no experience, have an EV specialist do the inspection and diagnostics, because a battery replacement can cost as much as a separate car
Spotted a mistake? Tell us →

Our articles

More articles →