← Model X

Tesla Model X (2019): Cabin Air Filter Replacement

The Model X cabin air filter is located in the HVAC module behind the right front footwell. Tesla recommends replacing it every 2 years. There is only one filter, no tools are needed, and all you have to do is remove the magnetic trim panel and the cover. This guide covers the cabin air filter only. The HEPA filter on vehicles with Bioweapon Defense Mode is located under the hood and is replaced using a different procedure.

DifficultyEasy Time15-20 minutes Steps15 ToolsNone required

Key figures

  • Replacement intervalTesla recommends replacing the filter at this interval. Reset the counter in step 14.
    every 2 years
  • Filter arrow directionthis is how the filter must be installed in step 9, otherwise it will work less effectively.
    toward the rear of the vehicle
  • Trim panel magnetsin step 12, check that all three have seated in place.
    3 pieces

Check these values against the manufacturer’s specification for your vehicle before you start.

Part

№PartAlternatives
01 Cabin air filter for Tesla Model, charcoal or standard1 pc.Find on Amazon → AlternativesEvannexMannBosch

Amazon links search by the part name; use Amazon's fit check for your car before ordering. We may earn a commission from qualifying purchases.

Step by step

15 steps · 4 stages
Stage 1 of 4 Preparation 3 steps
  1. Turn off the climate control on the touchscreen so the fan does not run during the replacement.
  2. Open the right front door and lower the right front window to make the work easier.
  3. Slide the right front seat all the way back.
Stage 2 of 4 Accessing the filter 3 steps
  1. Slowly and carefully pull down the footwell trim panel on the passenger's right side. It is held in place by magnets.
  2. Disconnect the electrical connector on the right side of the trim panel (it goes to the speaker) and set the panel aside.
  3. Squeeze the latch on the cabin air filter cover, remove the cover, and set it aside.
Stage 3 of 4 Replacement 4 steps
  1. Look at the airflow direction arrow on the old filter. The arrows should point toward the rear of the vehicle.
  2. Slide the old filter out of the HVAC module.
  3. Insert the new filter with the arrows pointing toward the rear of the vehicle. They must match the airflow direction printed on the filter.
  4. Place the cover onto the module and press until the latch clicks into place. The cover must seat tightly, otherwise air will bypass the filter.
Stage 4 of 4 Reassembly and check 5 steps
  1. Hold the footwell trim panel in place and connect the speaker connector.
  2. Press the panel in so that all 3 magnets seat in place.
  3. Return the seat to its original position, raise the window, and close the door.
  4. On the touchscreen, open Controls > Service > Maintenance and reset the cabin air filter replacement interval.
  5. Run the fan at different speeds. The air should flow evenly, without whistling or unusual noise from the cover.

Common mistakes and warnings

  • There are no threaded fasteners in this job, so no torque specs are needed
  • Pull the trim panel down smoothly to avoid tearing the speaker wire
  • If the new filter is installed with the arrows facing the wrong way, it will clean the air less effectively
  • Replace it every 2 years, and more often if you drive in dusty conditions or in a city with poor air quality
Spotted a mistake? Tell us →

Our articles

More articles →